[atlas] Probe disconnects
- Previous message (by thread): [atlas] Probe disconnects
- Next message (by thread): [atlas] Plan to Implement RIPE Atlas WiFi Measurements
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Paul van der Zwan
ripe-ncc at vanderzwan.org
Mon Oct 9 12:20:33 CEST 2017
Hi Johan, I had a look on my probe’s page but I cannot find a check box anywhere. Only things I see are the dhcp/static address selection options. Regards Paul Sent from my mobile phone > On 9 Oct 2017, at 12:01, Johan ter Beest <jterbeest at ripe.net> wrote: > > Hi Paul, > > >> On 08/10/2017 11:45, RIPE wrote: >> Hi, >> I have a probe ( #22583 ) at home connected via my DSL link, for IPv6 connectivity I use a Hurricane Electric ( tunnelbroker.net ) /48 tunnel. >> >> I noticed on the monthly report that my probe is showing lots of short ( 1-2 min) disconnects. >> >> But it only seems to happen when the connection address in the probe’s network tab is the IPv6 address. >> In that case the IPv4 Connection address is empty. >> >> If it’s showing the IPv4 the probe stays connected for days ( until the DSL link really disconnects). >> Is there a way to get the probe to ignore the IPv6 for connection status ? >> Or to mark it as disconnected when both iPv4 and IPv6 are disconnected ? > > You can restrict the probe to connect only on IPv4 if you want by checking the box in the network settings for IPv4: > https://atlas.ripe.net/probes/22583/#tab-network > > This will make sure the probe only connects to our infrastructure using IPv4 but the probe will still be available for IPv6 measurements. > > Hope this helps, > > Kind regards, > > Johan ter Beest > RIPE Atlas Team > > >> >> >> >> Best regards, >> Paul van der Zwan >> >> >> >> > >
- Previous message (by thread): [atlas] Probe disconnects
- Next message (by thread): [atlas] Plan to Implement RIPE Atlas WiFi Measurements
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]