[atlas] Replacing flash key
- Previous message (by thread): [atlas] Replacing flash key
- Next message (by thread): [atlas] Replacing flash key
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Karsten Thomann
karsten_thomann at linfre.de
Thu May 19 15:59:56 CEST 2016
Hi, do you use static IP's for the probe without any dhcp? My probe wasn't able to use the new USB key when it was attached to a network without dhcp (waited over 12hours). After it was connected to a port in another network with dhcp the probe recovered with the new usb key after some time. Kind regards Karsten Am Donnerstag, 19. Mai 2016, 16:52:18 CEST schrieb Marat Khalili: > My V3 probe (26656) disconnected yesterday, simple reboots didn't help. > Suspecting problem with USB key I first tried to replace it with a new > one. I took bog standard Transcend JetFlash 350 8Gb right out of the > wrapping and inserted it into a started probe 10 minutes after boot. Did > not format the flash key or alter it in any way, because someone > previously said that it is not necessary. Unfortunately, probe did not > come up, and the flash key seems unchanged after approximately 1 hour > wait. What should I do to switch to a new flash key? Also, did someone > tried connecting HDDs/SSDs, shouldn't they work better? > > (Probe did appear after I inserted previously used flash key into it, > but I suspect problem will re-occur in the future, so I'd like to know a > way to fix it more permanently.) > > -- > > With Best Regards, > Marat Khalili
- Previous message (by thread): [atlas] Replacing flash key
- Next message (by thread): [atlas] Replacing flash key
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]