[atlas] Power plugs for the Anchor nodes
- Previous message (by thread): [atlas] Power plugs for the Anchor nodes
- Next message (by thread): [atlas] Power plugs for the Anchor nodes
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Colin Petrie
colin at spakka.net
Fri Nov 15 11:51:33 CET 2013
On 11/14/13 5:35 PM, Nick Hilliard wrote: > So all you need to do is transform from -48VDC to say +16V/1A and feed that > to a 2.1mm connector. FYI, there's also a power supply header on the board (instead of using the 2.1mm jack): 4.15 JP15, DC Power 4 pins AMP MTA100 header, for connecting of an internal power supply of 5V to 28V DC., Pin 1 is the top pin, closest to JP 16. Please note that JP15 is NOT protected against reverse voltage. Regards, Colin
- Previous message (by thread): [atlas] Power plugs for the Anchor nodes
- Next message (by thread): [atlas] Power plugs for the Anchor nodes
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]