About RIPE | Contact  | Search | Sitemap    
Homepage RIPE  
RIPE Community Mail Archives
search  
     
RIPE Navigation Ends
About RIPE Maillists
Maillists Archive
Global Lists
Non Active Lists
RIPE NCC Navigation Ends
Next Section

Re: [dns-wg] Proposal to change the syntax of "nserver:" attribute

  • To: Peter Koch pk@localhost
  • From: Katie Petrusha katie@localhost
  • Date: Mon, 15 May 2006 11:59:47 +0200
  • Cc: db-wg@localhost, dns-wg@localhost

On Mon, May 15, 2006 at 10:30:20AM +0200, Peter Koch wrote:

Dear Peter,

> > nserver: [domain_name] /or/ 
> > nserver: [domain_name] [ipv4_address] /or/ 
> > nserver: [domain_name] [ipv6_address] 
> 
> What's the reason not to use one line per server and list all v4 an/or v6
> addresses within that one line?

'One name per line' syntax seemed to be more clear and short...

> > If [domain_name] is followed by an IP address, it must be inside the zone 
> > that is being delegated. Any level of a glue name is supported within the 
> > valid domain name syntax. 
> 
> <nitpick>s/inside the zone/inside the domain</nitpick>, since one might have
> a name server even in a deeper zone. _Unless_ however this was meant as a
> requirement, but then I can't understand the second sentence.

The intention is to accept something like:
domain: test.net
nserver: ns1.test.net 168.0.0.1
nserver: ns2.d2.test.net
... etc (glue any level under <domain>, like a.b.c.x.y.z.test.net)
and reject

domain: test.net
nserver: ns2.example.com 168.0.0.1

Hope it is clearer now; any suggestions about better and clearer phrasing 
are appreciated.

> > domain: example.com 
> > nserver: ns1.test.net 168.0.0.1 
> > nserver: ns1.test.net 0::0 
> > nserver: ns1.example.com 
> > nserver: ns1.d1.example.com 
> 
> That should probably read 'domain: test.net' (or better s/test/example/).

yes.

> > Consequences for the delegation checks: 
> > 
> > DNS checks applicable to glue records will be added to the Zone Delegation 
> > Checker (http://www.ripe.net/rs/reverse/delcheck/delcheck_descr.html)
> 
> Since I've not found the keyword glue on this page, could these checks be
> circulated to the dns-wg in advance, please?

All the DNS checks applicable to the 'normal' nameservers currently 
will be also applied to the glue nameservers. 

The only new glue-related checks will be:
1) Making sure all glue IPs listed in domain object are also listed 
in the zone at every nameserver
2) Glue name must be within the same domain (already listed above)

Hopefully that makes it clear. 
After getting all the comments and corrections, I can resend the 
updated version of the proposal.

--
Katie Petrusha
RIPE NCC




 

Next Section
     About RIPE | Site Map | LIR Portal | About the RIPE NCC | Contact | © RIPE Community. All rights reserved.
RIPE.NET Homepage LIR Portal RIPE Community